Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: renovator on March 02, 2021, 05:48:49 PM

Title: Probing with mach 3
Post by: renovator on March 02, 2021, 05:48:49 PM
I have had a probe for years.
I use to use it a lot, but haven't for about 10 years.
I think I must be doing something wrong.
Now I probe something then when I tell it to cut it out it trys to cut just like it probes I.E. up and down.
It never used to do that, it would cut smooth.
I think I must be missing a step or something.
Can anyone help?

Ken