Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: banditpowdercoat on October 10, 2007, 04:05:13 PM
-
OK, I am going to start designing my mill setup soon. I will be using a NC pod to interface my Xylotex driver board to my laptop. I was thinking about making a remote control stn for the main functions, NCpod has 5 inputs and an E-Stop. What would be some reccomendations for usefull Inputs. Just dont want to be like "Man, I shoulda added thaat finction" or "why didnt I add that?"
Thx in advance
-
I would want to be able to choose each axis, Have an MPG for sure, choose step size, Zero each axis, a go to zero button would be nice, enable to lock out the pendant, all except e-stop. Would have to have an e-stop. Cycle start, and cycle stop would be nice additions. I think one of the suppliers are going to release one soon.
Brett