Machsupport Forum

Third party software and hardware support forums. => HiCON Motion Controller => Topic started by: scrambled on February 22, 2021, 09:12:21 PM

Title: Following error
Post by: scrambled on February 22, 2021, 09:12:21 PM

Hi all


I was able to work on my flame/plasma table some this weekend, and I ran into a problem.

I do not know if this is a HiCON problem, or a Mach 4 problem.

When I use either the mpg hand pendant, or write a few lines of Goode using the MDI command, everything moves correctly.   I can get all three axis moving at the same time with zero issues.

When I use sheetcam to generate Gcode, and I run this code. When I get to the line that detects the top of the part with a g31, I start getting following error

“ Error:  following error limit exceeded on Motor 0.  Servo disarmed.

Do you have any ideas?


Thanks

Steve

Title: Re: Following error
Post by: TPS on February 23, 2021, 02:33:25 AM

have a look here:

https://www.machsupport.com/forum/index.php?topic=44331.0

sounds like the same Problem.