Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: R A on February 06, 2021, 05:58:10 AM
-
During the program I often get an e stop emergency. Sometimes none and sometimes several times in the same program. What could be the cause of this
-
This issue can be caused by electrical noise picked up on your inputs wiring (limit switches, estop, etc.). Do a forum search for electrical noise and you should find some info on; earthing, cable shielding, line filters, VFD noise, etc.
Tweakie.
-
Thanks for the reply i wil change the kable from the E stop
-
Thanks for the reply i wil change the kable from the E stop
Use good quality shielded cable with the shield connected to Earth at the controller end only.
Tweakie.