Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Bruce Hodgkins on January 22, 2021, 07:18:27 PM
-
Hi I have set up nc limit switches to a 6040 cnc with a bitsensor breakout board. Cannot get Mach 3 to recognise the switches. I have been through ports and pins a dozen times makes no difference. Connections on Bitsensor board are common to DCM and signal to in2. Hope somebody can help.
-
https://buildyourcnc.com/item/electronicsAndMotors-electronic-component-breakout-Mach3-USB-Board
a lot documentation here.