Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: waterfx on January 19, 2021, 02:41:48 PM

Title: A axis stepper rotation error
Post by: waterfx on January 19, 2021, 02:41:48 PM

Trying to use a axis for rotary scan.  I aligned X, Y axis to center of plate.  My A axis stepper is over rotating for a 360 degree program.  One full rotation of plate registers as ~300 degrees in controller.  The belts and gears are not slipping and there doesn't seem to be any tangible fault.

Title: Re: A axis stepper rotation error
Post by: TPS on January 20, 2021, 03:25:59 AM

then your step'/per for the a-axis are not set correctly.