Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Viking man on October 08, 2007, 06:48:31 PM
-
We have a Hercus PC 200 CNC lathe that is not working, it loses home. It has 8 position tool turret and uses servo motors with I believe Hewlet Packard HEDs encoders. I would like to convert it to to run under mach 3. Is it a good idea or leave it as is and have it repaired?
To have it repaired is a major pain in the neck as it is made in Australia, a traveling repair person goes across the U.S. and have to get on his schedule. :(
Mach 3 would be a much better interface. :) Thanks!!
-
It could be done.. you need to have a look at the servo drives from Gecko and CNCTeknix. Setting up the amps and wiring the machine is the hardest part of that project :(
Thanks
Brian
-
I have had some experience with PC200 yes you would be better off with a retro fit send me an email and we can chat
sapug_peter@internode.on.net