Machsupport Forum
Mach Discussion => Mach4 General Discussion => Topic started by: knothead on January 08, 2021, 04:23:58 PM
-
Can someone give me a hint as to where I need to input the height of my probe block for Z in Mach 4. Finally got it working and now would like to use it. Any help is appreciated.
Thanks,
Tim
-
What script are you running and what are you trying to set? Tool offsets ? Fixture offsets ? What type of tool offsets are you doing? Sorry but this all matters
-
Thanks for replying Brian. What I was looking for was the input area to insert the height of my probe block to compensate for when I used the probe for the Z setting. I found where I needed to do that, so all is good. Appreciate the response.
Tim