Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: MB76 on January 02, 2021, 05:56:52 PM

Title: Mach3 plugin hypertherm 105?
Post by: MB76 on January 02, 2021, 05:56:52 PM

Hi, I have recently purchased a CNC plasma table, It was designed to use a different plasma power source, I already have a Hypertherm 105 I used with a Swift-Cut table, which was very unreliable, at the moment I have to manually set the amps on the Hypertherm 105, Is there a plugin for this? It would be very helpful if there was
Cheers
Dave