Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: cncshoe on December 22, 2020, 03:02:27 PM
-
In the CONFIG top menu, when I click on Motor tuning nothing happens, it does not open. I left my home build cnc dormant. For a few years and on restarting noticed the X axis needed tuning. I thought of reloading Mach 3 (licensed program) but I cannot locate original I purchased about
7 years ago. I YouTubed this and found several which were not helpful, wondering if this is a common problem. Thanking you in advance for taking your time to help me resolve this issue.
ROBERT
-
Backup your profile, associated macros, screenset (if modified), license.
Reinstall Mach3, last version (062), copy back your backed up files, and you should be good to go.
-
BINGO....Works perfectly. Problem resolved I have nominated you as Best Friend for Life. Thanks for your help...stay healthy. Robert
-
Cannot open Motor tuning after a change from UC300 USB to UC300 ETH on the 5LPT board.
Everything runs smoothly, except that access to the Config/Motor tuning/ menu (Win 7 pro, Mach 3 v066) is not possible anymore.
Sure, a re-install of Mach3, a suggested above, is possible but an explanation would be better.