Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: rceebuilder on October 06, 2007, 09:49:58 PM

Title: Rotary help
Post by: rceebuilder on October 06, 2007, 09:49:58 PM


  I'm trying to do  rotary  cuttings  but  I could not  go  one step ahead so far. First  of  all  my A axis is not working. I enabled A axis and  marked as  rotary .To see A axis movements   I edited a 2d tool path .I have  replaced  all  X  letters  with   A  .Then  I loaded and run the g code. All other axis works but  A axis does not move. Am I doing something wrong?      ???

Murat
Title: Re: Rotary help
Post by: Chip on October 07, 2007, 12:20:36 AM
Hi, Murat

Hear's a xml and an A axis g-code file to try.

You'll need to change pin numbers for your stepper setup.

Hope this Helps, Chip
Title: Re: Rotary help
Post by: rceebuilder on October 07, 2007, 04:45:21 PM
thank you  works fine now.

Murat.