Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: dh42 on December 16, 2020, 08:56:22 PM
-
Hello
I'm exploring Mach3 turn for trying to help an user that is starting with Mach3 ; unfortunately I only know the mill side.
In Mach3 turn doc, page 23, we see an "ISO" (perspective) 3D view of the taper as on "turn1" picture, but in the software the 3D view is in "side" view, as on "turn2" picture ; where is the setting that allow to swith to an ISO view ? ... I can't find it ... (Mach3 3.043.062)
Thanks for your help ;)
++
David