Machsupport Forum
Tangent Corner => Tangent Corner => Topic started by: mikeg53549 on October 06, 2007, 04:29:58 PM
-
I bought a DYNA MYTE 2800 table top CNC milling machine made by Dyna
Mechtronics. I am looking for a copy of the manual or any information
on it. Anybody have this machine or have experience with one?
-
mikreg53549:
Yeah, I've got a 2800 (currently running under Artisan Software's "AHHA", but hopefully soon to be converted to Mach3). I've been running it for a couple of years, and its been a good machine.
I have most of the original manuals (original software user guides, electrical diagrams, parts lists, and some mechanical/maintenence details). What all do you want copies of?
ventuseu
-
I now went and bought most if not al the manuals from Dyna at $50 a pop, thank you for the offer, I converted mine to Mach 3 and it runs pretty damn good.
-
Sorry I didn't read your original post earlier.
When I get serious about upgrading my Dyna, I'll probably try to get your advice on some of the details of your upgrade :). (Right now I'm planning to replace the original drivers with Geckos, install direct drive steppers, and try to keep the spindle speed/mag brake controls intact...)
Regards,
ventuseu
-
I am looking for this component NEC R47 (see attached file) which is in the spindle control board of DM2000. It is Black & red in colour & printed 4 8102 on 1 pc & the other R47 35V M. Can anyone help to advise what is the name & where can I buy it?