Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: agisthos on November 30, 2020, 05:40:18 PM

Title: Mach 3 gcode loads in, but wont start feeding co ordinates.
Post by: agisthos on November 30, 2020, 05:40:18 PM
All of a sudden my Mach3 has quit working. It starts up, manual jogging movement works, and gcode loads in. But when starting the cut instead of the gcode co-ordinates feeding in line by line, it just stops at the very start.

What do you think the cause of this issue is?

Im using gcode that has been used before, and also tested other gcode I know has worked, and same thing.
Title: Re: Mach 3 gcode loads in, but wont start feeding co ordinates.
Post by: TPS on December 01, 2020, 04:30:12 AM
can you pls post one of your files, and describe where (line) it stops?