Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Bruce Hodgkins on November 27, 2020, 07:59:32 PM
-
>:( Have bought 6040est I have set it up and ran roadrunner test g code now the spindle won't run through the pc any thoughts? Bruce
-
Is it 0-10 volt analogue or just on/off by relay?
-
Sorry bit above my pay grade Spindle runs through a VFD. I have set up Mach 3 as per chinese instructions and it seemed to be behaving itself. It finished off the roadrunner. Now I cannot set the spindle speed just zeros all the time
-
We need more to work on, some pictures of the vfd, settings and the inputs/outputs will help