Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: EagleAD on November 23, 2020, 11:57:25 PM

Title: Mach 3 not zeroing when hitting encoder limit
Post by: EagleAD on November 23, 2020, 11:57:25 PM

When attempting to zero the Y axis the encoder limit activates as it should and retracts a few steps then tries to zero again and keeps repeating this behavior until I stop it.  The encoder limit works properly if I move it to the limits but this only happens when I try to zero the axis.  Anyone have a clue as to what is happening here?

Title: Re: Mach 3 not zeroing when hitting encoder limit
Post by: BGelektronika on November 24, 2020, 02:12:22 PM

Anyone please...