Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: bigdtraveler123! on November 15, 2020, 11:49:52 PM
-
I just got my diy mill running . But it seams being to run in minature.. The g code is in inches and mach3 is set in inches . Project is 5" x 12" but it engraves it about 1" x 2" . I am running a BL- usbmach v2.1 BOB. dont know if conflickting with mach3 or do i need a different BOB . does anyone have help for me ?
-
Try running the Axis Calibration wizard (Settings page) just to check that you have your Steps per Unit set correctly for each axis.
Tweakie.