Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: KolinH on November 10, 2020, 09:02:40 AM

Title: Incomplete GUI
Post by: KolinH on November 10, 2020, 09:02:40 AM

Hi
Newbie KolinH here, im not off to a good start. On receiving my new cnc with mach3 installed for me on my laptop going through a uc100 to the breakout board.
The mach3 screenset is incomplete the reset button has no text, the stop button does not exist and the XYZ buttons are blank.
So I have no confidence in continueing any set up.
Any one got any ideas.
Thabkf for your help
Screenshot attached
Cheers
Kolin

Title: Re: Incomplete GUI
Post by: Tweakie.CNC on November 11, 2020, 03:08:35 AM

You are using a very old version of Mach3. The final version can be downloaded from here; https://www.machsupport.com/wp-content/uploads/2013/04/Mach3Version3.043.exe

Just run the install over the top of your existing version but make a backup of your existing Mach3 folder just in case you need to transfer any custom macro's etc.