Machsupport Forum
Support => Downloads => Post Processors => Topic started by: Troncatore on November 06, 2020, 02:46:35 PM
-
Hello everyone
I'm encountering a lots of problem using the 4th axe on my Bf20 using Fusion 360 post processor for Mach3. Does someone encountered this problem? Maybe Mach3 need some adjustment?
Thanks in advance
-
Not a single 4th axis move in the program so check your CAM settings.
-
Hi Graham...Please let me know how I have to do...because simulation is ok... I just obtained this program...
-
Its working on my Mach3, no idea if its what it should look like but that's all I can do.
-
Yes it is also on mine....but A axe doesn't move correctly...and tool never touch the material...exceeding my table geometry!!!! I need a right post processor...!