Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Ronr on October 28, 2020, 08:21:52 PM

Title: reinstalling Mach3 and cannot reverse Y axis direction
Post by: Ronr on October 28, 2020, 08:21:52 PM

I just had to reinstall Mach3 on a system that was working before and now I cannot change the direction of Travel on the Y axis. Change the setting in the MotorHome/Softlimits  screen save setting rebotted system and still goes in the reverse direction. any help would be appreciated

Title: Re: reinstalling Mach3 and cannot reverse Y axis direction
Post by: TPS on October 29, 2020, 03:14:00 AM

try Config -> Ports&Pins -> Motor Outputs -> Dir LowActive

Title: Re: reinstalling Mach3 and cannot reverse Y axis direction
Post by: Ronr on October 29, 2020, 07:02:19 AM

OMG how could I have missed this thanks so much