Machsupport Forum
Third party software and hardware support forums. => PoKeys => Topic started by: taiello6683 on October 15, 2020, 11:32:57 PM
-
So I’m very new to Mach4 and CNC controls. I am trying to enable the limit switch override function on the jog screen and am having no luck. Once it trips a limit I’m stuck without manually backing off the switch. The button for override never becomes active. I’m pretty sure it’s a setup issue but cannot find the right way to configure. Any suggestions?
-
You have to set up your limit behavior within the Pokeys plugin .
-
The limit switch works fine. The problem is I cannot override the switch once it's tripped. There is a soft button on the jog screen that is "Limit Switch Override" but it is not active. I have found the input setting related to that function but do not know how to configure