Machsupport Forum
Mach Discussion => Mach4 General Discussion => Topic started by: ArtistInSP on September 30, 2020, 08:37:25 PM
-
I am running Mach3 with a Warp9 Ethernet SmoothStepper and C25 BOB.
When I select the jog mode to Step and jog it is incredibly slow. I have the Jog Rate set to 100%.
When I jog using the keys or the buttons on the onscreen pendant in "Cont" mode it jogs at the correct speed.(3048 mm/min)
When I set it to "Step" it is moving incredibly slow.
What is going on? I had no problem before reinstalling the software after I switched my controller card to the Smoothstepper. I reinstalled it to have a clean setup for the smoothstepper.
Am I missing something?
Please help!!
Thank you
Mark
-
I thought with ESS you need to hold down the shift-key to be about to jog properly
Read Warp9 FAQ
https://www.warp9td.com/index.php/faq/faq-mach3#KeyboardJogging
-
I thought with ESS you need to hold down the shift-key to be about to jog properly
Read Warp9 FAQ
I can jog in continuous mode just fine, In Step Mode it jogs but VEY VERY slowly with and without the Shift Key.
I also found that it is not all the time. I can get it to jog after running a cut file.