Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Dsc1214 on September 09, 2020, 02:31:56 PM
-
ive been using the text engraving wizard on mach 3 loader and its been working.
now when I set everything and type what I want engraved and hit cycle start it moves in the y axis where it needs to be then drops down past where I set my z and goes an inch or so into the board im engraving. any suggestions on what is wrong and how to fix it ?
-
Could you perhaps attach your problem Gcode file.
Tweakie.
-
After re checking my settings probably 100 times I finally figured out the z top setting was wrong. but thanks for the reply