Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: learman on October 02, 2007, 08:20:30 AM
-
hello
using Mach 3 to induction harden pins for Ford,, and it works awsome!! I have setup external start, stop button using oem triggers. the problem is when I press the stop button It stops the g code but leaves whatever outputs that have been turned on,, on,, I have looked through the oem tigger names and cant seem to find one that will shut all outputs off.
Thank
Josh
-
General config, check "turn off outputs" under pgm end section
-
I have that set already, thats for your M30 command.
thanks for the reply
-
Have a look at the Brain, shouldnt be too hard to reset the outputs to what you want.
Hood
-
Hello Josh Learman,
I am an automotive induction heat treater also, close to Detroit. I have built a scanner and "lift and rotate" and several drop fixtures with PLC's but I never considered using Mach 3 as a control, it could save a lot of money and standardize all my interfaces I just completed a three axis engraver (A personal project) but still trying to stop occasional "External Emergency Stop Requested" messages.
Induction noises from the stepper motors I suppose. But that is nothing compared to High Frequency Induction noises.
I would be interested in how you control your logic signals around all that noise.
bill at wulkaninduction dot com