Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: fevalini on August 26, 2020, 12:02:15 PM

Title: RnR R08 ECO MOTION 2.0 + Spindle Motor - Connection
Post by: fevalini on August 26, 2020, 12:02:15 PM
Hi guys good morning!
I need a help to make the connection and activation on the correct pins.
I connected to the tutorial below, also using the third source with 10v. But I don't know how to connect the OUT outputs to trigger the spindle.

Thanks for the opportunity.
Title: Re: RnR R08 ECO MOTION 2.0 + Spindle Motor - Connection
Post by: reuelt on September 12, 2020, 06:54:20 PM
Hi guys good morning!
I need a help to make the connection and activation on the correct pins.
I connected to the tutorial below, also using the third source with 10v. But I don't know how to connect the OUT outputs to trigger the spindle.

Thanks for the opportunity.
Your RnR USB ECO Motion board does not have any relay.
Either replace with another controller board that has a relay or add a $5 5V relay (designed for Arduino) to convert one of the outputs to a switch.

(see attached)

The relay can then switch on/off your spindle controller.