Machsupport Forum
Mach Discussion => Mach4 General Discussion => Topic started by: ryounger on August 17, 2020, 12:32:55 PM
-
When I run a CNC program sometimes the cut comes out lopsided almost as if the Y or the X axis "slipped" and didn't travel as far as it was supposed to before the next cut. Is this a hardware issue or a software issue? It only seems to occur infrequently and on larger cuts?
-
Could you perhaps post a picture of the lopsided cut ?
Tweakie.
-
maybi you mean that its like "filet" or "chanpher" the corner?
if so ,look here many many talks about CV and exact stop