Machsupport Forum
Mach Discussion => Mach4 General Discussion => Topic started by: Len-Tikular on August 12, 2020, 05:06:02 AM
-
I'm looking for a simple procedure to Auto zero my Z axis when an M6 tool change is executed.
My mach3 setup had an extra button on the screen for this.
Thanks
George
-
just read the manual,there inside very clear change tool and very clear measure tool length procedure
you can do as boton,as m function....
and of course need add yours specific requirement
-
Thanks Katz, I didn't see that section in the config/installation guide. Point me in the right direction please.
Thanks
George
-
lua scripting guide ,page 20-automatic tool height setting page 22-tool change