Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: N4NV on July 12, 2020, 01:04:20 PM
-
I am running Mach 3. I don't know what I did but my mill will no longer rapid when I press SHIFT + >. It will advance one increment at a time when I press CNTRL + >. When I press just >, it will move at 41 IPM, no matter what rate I have it set in the jog screen. If I run a gcode with a G00 instruction, it rapids at the full 100 IPM. Any idea what I screwed up? It used to work properly.
Thanks,
Vince