Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: lagogo on June 25, 2020, 12:30:06 AM
-
It is very strange, when mach3 work none of my motors would work properly. They would only turn slowly and vibrate profusely,lose steps.
1 i set Task Manager-Processes-mach3.exe-affinity - cpu0 or cpu1 , it not useful,motors still slowly and vibrate profusely
2 when mach3 working ,i run any other software at the same time , the Motors run smoothly immediately。
3 i set win+r-msconifg-boot.ini-advanced-/NUMPROC(N)=1,reboot laptop, the Motors run smoothly immediately
please help , i dont want use only 1 cpu ,coz it is core 2 dual ;D
regard!
-
Which motion controller are you using ?
Tweakie.
-
Which motion controller are you using ?
Tweakie.
i use LPT port motion controller :)
cpu is Intel Core 2 Duo processor, P8700 - 2.53GHz, 1067MHz FSB, 3MB L2 cache
-
Unfortunately Mach3 will not operate correctly using a Laptop with a Parallel Port - you need to be using a PC with Parallel Port or a Laptop with motion controller.
Tweakie.
-
The Mach3 requirements are here; https://www.machsupport.com/software/mach3/
Tweakie.
-
Unfortunately Mach3 will not operate correctly using a Laptop with a Parallel Port - you need to be using a PC with Parallel Port or a Laptop with motion controller.
Tweakie.
so i need change an usb motion controller ?i thought parallel port is better than usb :(
-
If you decide on a motion controller then choose one from EU or USA manufacture - avoid anything from China.
If you choose anything from a business that is listed in this thread then forum support may be limited; https://www.machsupport.com/forum/index.php?topic=24331.0
There are many to choose from but the Warp9 ESS is good.
Tweakie.
-
If you decide on a motion controller then choose one from EU or USA manufacture - avoid anything from China.
If you choose anything from a business that is listed in this thread then forum support may be limited; https://www.machsupport.com/forum/index.php?topic=24331.0
There are many to choose from but the Warp9 ESS is good.
Tweakie.
thank you .
this is the video of the problem :) https://www.youtube.com/watch?v=PWwS_NvnwKg (https://www.youtube.com/watch?v=PWwS_NvnwKg)
-
Try following the instructions in this link
http://support.machsupport.com/en/kb/articles/mach3-xp-optimization-txt-steps
especially changing from ACPI to standard PC
Marsha
Driving my CNC with old Dell D600 1.6mhz laptop