Machsupport Forum

Mach Discussion => Mach4 General Discussion => Topic started by: ByrdMan on May 14, 2020, 12:52:26 PM

Title: Loop-d-loop G41
Post by: ByrdMan on May 14, 2020, 12:52:26 PM

When I use a G41 to compensate, my radius cut goes crazy with another loop to prep for the next move. Between the G02 and the next G01 is where I get the circled prep move.

g41
g01 x.671 y-.0729
g02 x.8957 y-.333 r.282
g01 x1.2837 y-.33

ByrdMan

Title: Re: Loop-d-loop G41
Post by: ByrdMan on June 01, 2020, 08:47:24 AM

I am using Mach4 4.2.0.4300 Build 4300

Title: Re: Loop-d-loop G41
Post by: Graham Waterworth on June 08, 2020, 08:34:54 PM

Was the code written for G41 from the start or have you added it later?