Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: antmac on May 11, 2020, 11:03:32 PM
-
running xp mach 3 working on computer but not moving machine using usb can someone please help me as i am new
-
Hi,
you haven't provided much information.
You say you are using USB....what USB board specifically?
I presume that it is a USB motion controller, if so you have the USB controller plugin installed and selected as motion controller?
Craig
-
i dont know my wife bought me a 6040 cncest running a prt-e1500w controller from china doesnt have parralel just usb printer cable can get program to work on computer but wont control machine but the motion controler i dont know which one i have any help for a begginer would be appreciated and some patience with me would be appreciated
-
Can you post some pictures of the control and the board inside it, did you get any software with it, if its USB there will be a driver you need to load/copy into Mach3
When you start Mach3 go to menu 'Function Cfg's' and click on 'Reset Device sel...' Close Mach3 and start it again, post a picture of the small device window that pops up.