Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: sanel_bico on November 17, 2005, 02:27:04 AM
-
Hi,
we are new users of Mach software. We have problem with one axis on our plasma cutting mashine. On this axis we have small ratio portion and motor need only few steps (7) to make one unit (1mm). I case that we using these number of steps we have very noisy moving. Some other software like TurboCNC or EzCNC have smooter moving on same machine.
How we can solve this problem?
Thanks
-
please check the pulse width and accel settings
Hope that helps
Brian