Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Heli Guy on September 24, 2007, 01:09:37 AM

Title: OEM Code 352, 353, 354 and 355
Post by: Heli Guy on September 24, 2007, 01:09:37 AM

Hello All
Trying to use OEM codes 352 to 355 with no sucsess - most of the OEM codes work other then these 4. Has anyone tried them ?
Thanks
Todd

Title: Re: OEM Code 352, 353, 354 and 355
Post by: Brian Barker on September 25, 2007, 08:55:36 AM

Could you tell us a bit more about what you are trying to do??
Thanks
Brian

Title: Re: OEM Code 352, 353, 354 and 355
Post by: Heli Guy on September 25, 2007, 11:05:04 AM

I am trying to run X and Z axis together and Y and A together.
Thanks

Title: Re: OEM Code 352, 353, 354 and 355
Post by: Heli Guy on September 25, 2007, 11:05:13 AM

I am trying to run X and Z axis together and Y and A together.
Thanks

Title: Re: OEM Code 352, 353, 354 and 355
Post by: Brian Barker on September 27, 2007, 09:55:47 AM

Are you doing this with the P Port or an external device?

Can you just setup slaving under the slaving settings???

Title: Re: OEM Code 352, 353, 354 and 355
Post by: Heli Guy on September 27, 2007, 11:31:35 AM

I am emulating a parallel port pins -
I tried to slave, but since I am using a 4 axis machine, I need to be able to slave but a few sec later to use it as a single axis
Also I can't find a way to slave Z to a and at the same time A to Y

Title: Re: OEM Code 352, 353, 354 and 355
Post by: Brian Barker on October 04, 2007, 09:09:00 AM

So you would like to change what axis is slaved on the fly??
Don't think we can do that :(

Title: Re: OEM Code 352, 353, 354 and 355
Post by: Heli Guy on October 04, 2007, 10:50:05 AM

So what are the OEM codes 352 to 355 ?
Did anyone test them ?
I was able to get 352 to work, on the 2.X version but not on the 1.8X version
353, 354 and 355 didnt work on any version

Title: Re: OEM Code 352, 353, 354 and 355
Post by: Brian Barker on October 07, 2007, 09:57:15 PM

Could you please tell a bit more about what it is that you are trying to do???

A bit of code so we can see what you are up to would be a great help.

thanks
Brian

Title: Re: OEM Code 352, 353, 354 and 355
Post by: Heli Guy on October 10, 2007, 12:02:26 PM

I am building a cnc foam cutter and need to move both axis with one key
The way it works now is that i need to hold two buttons on the keyboard in order to move two of the X axis for example.
I want to hold one button and move both X axis and hold down a different button and move them the other way
Same for the Y axis - want to move both Y axis by holding one button

I saw that the OEM codes 352 to 355 enable me to do so, but I can't get them to work

Thanks for your help