Machsupport Forum
Mach Discussion => Mach4 General Discussion => Topic started by: jorgenbli on April 30, 2020, 06:23:14 PM
-
Is there a way to avoid that mach4 forgets the current spindle speed setting after stopping a program. Sometimes I need to stop a program somewhere into it, and when I then start up the program again (from where I stopped it), the spindle will start at its default lowest speed. In order to fix this, I need to issue an S command on the MDI every time before starting within a program. This annoys me, as I see no reason why the spindle speed is reset at stop.
-
Hi,
if you use <FeedHold> rather than <Stop> then yes its possible.
Look in Mach's Control plugin, in the General Setting tab, there you will find settings to determine what happens to the spindle when a <FeedHold>
is encountered.
Craig
-
Hi,
see attached.
Craig