Machsupport Forum
Mach Discussion => Mach4 General Discussion => Topic started by: edcross on April 30, 2020, 04:27:23 PM
-
Anyone have trouble with vcarve desktop v10 and mach 4 v 4300 with PMDX 411 smartbob , ERROR = cannot communicate with device.
Ed
-
Hi,
ERROR = cannot communicate with device.
That sounds like a communication error bewteen the PC and the PMDX-411.
Will the machine respond to MDI commands?
Craig
-
Agreed. This is highly unlikely to have any to do with Vcarve.
Most likely it is due to electrical noise disruption of USB communications between the PC and the PMDX-411.
The two most common causes are ground loops or electrical noise related to the spindle motor or its driver.
-
It will not reset until you close mach 4 and unplug/plugin smartbob
Ed