Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: clax on September 22, 2007, 08:18:40 PM

Title: A axis slave to X axis and B axis slave to Y axis
Post by: clax on September 22, 2007, 08:18:40 PM

Hi, I need to configure: "A axis slave to X axis and B axis slave to Y axis"  but in the menu config -> slave axis there is only one possibility; is possible to make this?

Many thanks

Clax

Title: Re: A axis slave to X axis and B axis slave to Y axis
Post by: Chip on September 22, 2007, 08:54:20 PM

Hi, Clax

Don't now when it was added but latest ver of Mach3 2.47 has what you need.

Hope this Helps, Chip

Title: Re: A axis slave to X axis and B axis slave to Y axis
Post by: clax on September 24, 2007, 06:29:51 PM

Thanks, I will try that.