Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: moxy on April 14, 2020, 05:10:54 PM

Title: signal inputs
Post by: moxy on April 14, 2020, 05:10:54 PM
Hi All, Years since I have been on the forum. I have an RNR motion controller that I'm using on my plasma machine and x,y,and z control is working ok. when running a gcode file the torch on triggers fine but the thc zup and zdown do nothing? I checked on the rnr board connectors and the relevant inputs are triggering ok but giving no z control. How do I assign an action to an input signal? Set thc ports to 3 and signals to 10 11 and 12 in  ports etc config file.
Title: Re: signal inputs
Post by: joeaverage on April 14, 2020, 05:19:59 PM
Hi,
I don't think the RnR board supports THC.

Craig