Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: aquanaut on September 21, 2007, 07:32:19 PM

Title: Deep cut trips the reset
Post by: aquanaut on September 21, 2007, 07:32:19 PM

When I set my depth of cut anything over about .125 the machine tends to trip the reset.  I'm running the Xylotex system on a Sylsolva machine that I built. Anyone have any ideas?

Title: Re: Deep cut trips the reset
Post by: vmax549 on September 23, 2007, 05:16:23 PM

Try setting the debounce up to about 2000, you may have a vibration that is tripping a limit  switch. What does the error message say in the message box???