Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: cropwell on April 02, 2020, 09:51:03 AM
-
At the moment my machine is unavailable due to a workshop refurb.
Can anyone confirm whether Limits are enabled or disabled during Homing? If they are disabled then I have a dangerous situation if I have a wiring fault on the Homes as they are NO inductive switches. The Limits are NC microswitches, so that would provide a safety net.
Thanks,
Rob
-
Hi Rob.
Of course, limits are ignored if the limit sw also acts as a home.
I tested a separate limits and home switch configuration by emulating to separate inputs and found that even though the inputs are separate, Mach3 still ignores the emulated limit sw trigger while homing.
I would think it should not be that way ... but it is what it is.
Russ
-
Hi,
Is there any way to change this behavior? It is desirable that the limits are active when limit sw does not act as home.
thank you
T.