Machsupport Forum
Mach Discussion => Mach3 under Vista => Topic started by: metalmickey on March 26, 2020, 07:56:17 PM
-
I am running the current version of Mach3 on XP 32 bit and ,using a photo interrupter on single slotted disc pick up,
I cannot see any movement on the spindle DRO. What am I doing wrong.
Ps. The electronics have been checked to the end of the parallel port extension lead and all appear to be OK.
-
You need to have the input port and pins set for index and then set the index de-bounce to 0 or 1 in the general config screen.
Can you see the index LED flash in the diagnostics screen if you turn the spindle by hand?
-
Thanks for the rapid reply. No I don't see the LED flash when I rotate the chuck manually. I am currently making enquiries with Artsoft about the currency of my licence as it may have disappeared with a deceased older computer, although a hard drive transplant was attempted.
Anyhow I am currently waiting for a reply about this.
Thanks again ,
Mike Patterson