Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Maxxk9 on March 19, 2020, 08:26:10 PM

Title: Mach 3 4th axis display
Post by: Maxxk9 on March 19, 2020, 08:26:10 PM

I am setting up a rotary axis on my plasma cutter for tube profiling. Unfortunately,  I cannot figure out how to get Mach 3 to show the 4th axis on the screen. I have finished enabled and configured the A axis, but it will not show on the main screen. Any ideas?

Title: Re: Mach 3 4th axis display
Post by: TPS on March 20, 2020, 08:14:56 AM

taht is not depending on your Setup, is depending on the screenset you are using.