Machsupport Forum
Third party software and hardware support forums. => HiCON Motion Controller => Topic started by: scrambled on March 19, 2020, 06:20:14 PM
-
Hi all-
My plasma table has not worked in years, so I decided it was time for a rebuild.
I ordered a HiCON integra from Vital systems, and switched from Mach 3 to Mach 4
I have to table moving in all directions, but it is choppy at best for the y and Z.
Can someone explain how to tune the motors in both Mach 4 and the Hicon configuration page?
they are 850 IN oz motors with a 5 to 1 gear box
thanks
steve
-
Integra 7866 comes with 30 min of free support using Team Viewer we can look into your motor tuning. Please send an email describing your issue and your available times to support@vitalsystem.com
-
Thanks, I did not know that. I have to wait for warmer weather so I can open the shop doors and get my internet connection.