Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Howard1 on March 14, 2020, 07:12:45 PM
-
I can run the entire job no problem but when I close Mach 3 it gives me an error triggered. When I restart I have to Ref. all home each time. Any ideas what would cause this.
-
Hi,
When I restart I have to Ref. all home each time. Any ideas what would cause this.
That what you're supposed to do. When you first turn on the machine it does not know where it is, unless you direct
it to some repeatable and specific location (home).
Craig
-
But why the error triggered when I exit
-
Hi,
I'm only guessing but when Mach shuts down it saves its current position (machine and work coordinates)
and it sounds like it is not doing so thereby causing an error.
Craig