Machsupport Forum
Mach Discussion => Mach4 General Discussion => Topic started by: jevs on February 27, 2020, 08:44:21 PM
-
I do not see a post processor listed for Mach4, only Mach3.
Anyone know what post processor I should be using for Mach4 (mill)?
-
Hi,
the Mach3 and Mach4 Gcode dialects are almost identical therefore you can use a Mach3 post.
Craig
-
Hmm. I read there are some differences...
https://www.machsupport.com/forum/index.php?topic=37774.0
I just want to make sure I get started with the right stuff and do not limit Mach 4 by using Mach 3 posts.
-
Generic Fanuc will do. If you want to get picky, Fanuc 21i We made it Fanuc compatible so people didn't have to worry about a special post processor.