Machsupport Forum
Mach Discussion => Mach4 General Discussion => Topic started by: KatzYaakov on February 26, 2020, 05:16:01 PM
-
hello ,i have have that problem ,only when mach didn't close well ,but its something can happened
but when its happened i cant change the status its stack on"T on m6 line is next tool"
and even i change to second option ,when i save ,close the window ,open again its back to first option
-
I had this issue a while ago. I think I had to replace the ‘parameters.ini’ file in the Profiles folder
-
can someone from mach help?