Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: DennisF on September 18, 2007, 01:11:13 PM
-
Hi Brian and Art
I haven't checked back for a few month's and was wondering if you guy's got around to working on the lathe part of the program yet.
Rg's
Dennis
-
Not at this time but I do think the time will be soon... Art has been talking about it .
-
OK Brian
Still waiting patiently.
Dennis
-
Okay.. we will try not to push you to long... there is so much that we need to do at this time :( The Video Plugin that I did was for fun and not much more then that! I have been working on code that was no fun and I needed a to to play with :)
Looking forward to getting lathe done
Brian
-
Sounds good Brian, thank you for this. Just wondering, will the Lcam for lathe replace the wizards already there, or will it be a DXF input type addition to the wizards? As I have never used Lcam, is it integral with Mach, or a stand alone program?
Dave A.
-
Thanks Brain
I orignaly purchased Mach for the lathe application but also understand that thing's happen and it always take's longer then you expect.
Dennis
-
Lcam is what will be used to make a DXF into a lathe program...
I hope the work slows down and I can get back at Lcam hard! I would like to have it doen for the most part... I have about 2 weeks work to finishe what I need to work on in Lcam.