Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: sbloom67 on January 25, 2020, 11:13:18 PM
-
Hi All,
Is there a way to home just the Y axis. Also my Y axis has a slave "A" attached. How do I make sure they go back together ?
Thanks Steven
-
Ont the diagnostic page, you can home the axis's individually.
-
With many motion controllers the command you are looking for is the following:
G28.1 A x (where A is the axis and x is coordinate where the motion slows down for homing)
To home slave axes togheter, tick the option in the general configuration tab ("Home slave with master axis")