Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: yercik on September 17, 2007, 01:43:44 AM

Title: Feedrate over problem
Post by: yercik on September 17, 2007, 01:43:44 AM

There is a bug with the FRO. When I change the FRO value (Ex: %150), the feedrate increases (not limited to maximum axis speed).

Title: Re: Feedrate over problem
Post by: Chaoticone on September 17, 2007, 06:58:32 AM

Have you tried to check the No FRO on Queue check box in general config. to see if that helps?

Brett