Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Guntruck1776 on January 13, 2020, 02:43:16 PM
-
I know there are videos on youtube about lots of stuff, BUT I have bad cell coverage and no wifi where I need it
I downloaded the Mach3 demo to play with it and like it, I just need to figure out what does what, Is there a PDF manual?
Also I programmed my first engraving and it runs smooth and looks right, basically running it in dryrun environment (nothing hooked up to it, I am waiting on a Parallel cable to connect to router and then set it up) it is letting me play with controls
-
Link to the Mach3 manual:
ftp://ftp.machsupport.com/Docs/Mach3Mill_1.84.pdf
-
Thank you!!!!
-
Your welcome, ;)
RICH