Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: beejay7018 on December 23, 2019, 05:19:21 PM
-
I'm using a XPro4 breakout board which has wiring for limit switches. I've got the switches connected to the board but no display on the Mach3 software. I get a tone from the computer when switches are depressed but no interrupt from the software. I'm sure it's my own stupidity but what do I need to do to rectify the situation?
-
Common faults are:-
Board is not enabled.
Boards works at 3.3V, Mach needs 5V.
Board needs more than one power supply.
Check if inputs need to be at 0V or 5V.
-
Maybe check the obvious and check the ports and pins to make sure they are enabled